Sharp MFP Scan to Network shared folder

On windows 10 in order for scan to network to work we will need to enable SMBV1. By default on Windows 10 only SmbV2 and V3 are enabled.

This is the command to check the status of which versions are enabled


In order to enable SmbV1

Set-SmbServerConfiguration –EnableSMB1Protocol $true

This is the link about enabling the SmbV1


By |2018-07-04T13:18:40+00:00July 4th, 2018|Uncategorized|0 Comments

Delete an object from Azure AD synced from On Premise

Sometimes we need to delete an object from Azure AD which is synced with the local AD but despite moving the object (user, group or a contact) to a non-synced OU, which is technically equivalent to asking Azure AD to delete the object, the deletion does not take place. As the objects are synced from local AD so we cannot delete the object directly using the Office Admin portal


So one of the obvious choice in this particular case is to stop the sync from local AD to Azure AD. We can stop the sync using this command

Set-MsolDirSyncEnabled –EnableDirSync $false

Although it can take up to 72 hours as per Microsoft documentation, but usually it takes less. In my case I disabled sync before leaving from work around 5 pm in the evening and next morning at 9 am I was able to delete the object using the Office Admin portal. Once that is done we can re-enable the sync.

Set-MsolDirSyncEnabled –EnableDirSync $true

To check the status of the sync this command is used:












By |2018-05-15T08:30:22+00:00May 15th, 2018|Uncategorized|0 Comments